Report
![[Laser cut and engrave] P2 Slats Dispenser - magnetically attached](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/58c29f42-60fc-46fa-b024-d29d163cc133?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
P2 Slats Dispenser - magnetically attached
InstructionSlats-Dispenser
.xcs
Application scenario
Laser (15min)
Machine & module
xTool P2
55WMaterial used
4mm plywood
161
1017
Information
I often kept the slats either in a box or simply in the right-hand riser base drawer. They are unsorted and cannot be removed quickly and easily. This dispenser can be attached to the left-hand side of the riser base, as this is not hinged anyway.
Instruction
1
Step1: Open the file in XCS and let the laser process it.
Preview
Preview
All parts are cut out in this step. Please note that a 4mm thick material should be used to ensure that the parts fit together.
2
Step2: Assembly and gluing together
Preview
Preview
I recommend inserting the smallest parts into the back part first and then attaching the side parts later.
My tip is to take a small rectangular piece of wood and remove the excess glue (see picture).
3
Step3: back part and glue on some magnets
Preview
Preview
Finally, you can attach the back part with glue.
I glued on magnets to prevent it from tipping over when I put it next to the P2.
4
Step4: After the glue has dried, apply and refill the dispenser.
Preview
Preview
Preview
Have fun and enjoy it!
Comments
