HomeTemplatesDecorHome DecorLighting
scrapbookmemories
Report
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Night Light with Dog Paws cuts out

Instruction
Tea light Dog Paw.xcs
Tea light Dog Paw
.xcs
Application scenario
Laser (75min)
Machine & module
xTool M1
10W
Compatibles · 8
Material used
3mm Birch Plywood
210
1008
Information
       Customized Night light with Dog Paws
Instruction
1
Step1: Prepare 3mm Plywood or MDF board
Preview

Prepare a piece of 260x180mm rectangle 3mm birch plywood or 2-3mm medium density fiber board to be placed on the honeycomb base bed. Hit on the auto measure and the settings. Run framing to make sure it will cut within the plywood.

2
Step2: Interlock joints
Preview
Preview

It may be easier to use some adhesive on the joins when assembly on the wall. Finally the base add adhesive around the inner bottom of the tealight. 

Comments
Remixes
xTool Supplies Used in This Template
xTool M1
xTool M1
3mm Birch Plywood
3mm Birch Plywood

License

CC BY-NC