Report
![[Laser cut and engrave] Pet Frame Magnet](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/122e4941-8e34-4e9f-8581-4cf4d60a25d7?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Pet Frame Magnet
Instructiondogmomframe
.xcs
Application scenario
Laser (45min)
Machine & module
xTool M1
10WCompatibles · 11
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
45
411
Information
Pet lovers here is a cute simple magnet to show of your fur baby,
Instruction
1
Step1: Design
Preview
Preview
Preview
Preview
- Create a square 5" x 5"
- create another square inside that one leaving enough space for text at top and bottom
- set both squares to cut
- Add any text you may want
- If you want pets name to be cut out make a copy and set it to cut
- any text at the top can be set to engrave
- add any graphics to your design you might want. I add a pet paw to this design
- Click on the smallest square and make a copy and paste it on the page
- create outer outline of this one
- Make a copy and paste the bigger square
- set to cut
- set the objects and “edit nodes” on the right side panel
- click the scissors and clips the top of the rectangle off
- create a small rectangle and place over the places the scissors didnt get and “unite at overlap”
- set to cut
2
Step2: Laser
Preview
- Auto measure you material
- make sure all your objects are set to the correct settings
3
Step3: Paint & Assembly
Preview
Preview
Preview
3 More images
- Glue your thin frame on the backing making sure its flush on all three sides
- now glue this pieces to the back of the frame
- Paint your letters
- Glue your letters in the scored lines
- glue your any graphics you may have added
- glue your magnet to the back of the frame inthe center
- Stick your favorite photo of your fur baby in it and display it on the fridge.
Comments
