indiriWOOD
Report

Dollhouse Bed

Instruction
DollhouseBed.xcs
DollhouseBed
.xcs
Application scenario
Laser (15min)
Machine & module
xTool P2
55W
Compatibles · 8
Material used
3mm Basswood Plywood
108
788
Information
      A double bed for a dollhouse
    
Instruction
1
Step1: Adjustments and Cut Out
Preview

The “3” mm wood that I was using is actually 2.7mm thick.  If yours has a different thickness then you will want to use the Vector Edit tools to make the tab openings in the headboard and footboard thinner or thicker to match your material.

If you want to change the design in the headboard now would be the time to do that, too.

Let's cut these out with 100 power 35 speed.

2
Step2: Sand and Paint or Stain
Preview
Preview
Preview

Test fit your parts to make sure they will fit together well.

Sand any obvious burn spots to make them look nice.

Use paint or stain on the parts while they are separated so you're sure to get into all the parts.  I used a wipe on wood stain.

3
Step3: Assembly
Preview
Preview
Preview

Glue the headboard onto the bed.  I used super glue but any wood friendly glue is good.

Glue the footboard onto the bed.  It should just fit right into the slots since we test fit earlier.

Flip the bed over and glue the bed rails on to the bottom.  I inset them a little bit for a more interesting look.

Arrange in your dollhouse!

Comments
Remixes
xTool Supplies Used in This Template
xTool P2
xTool P2
3mm Basswood Plywood
3mm Basswood Plywood