HomeTemplatesDecorHome DecorShelves & Holders
scrapbookmemories
Report
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool M1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Small coaster stand for 100mm slate coaster

Instruction
Coaster small stand.xcs
Coaster small stand
.xcs
Application scenario
Laser (15min)
Machine & module
xTool M1
10W
Material used
3mm plywood
3mm Basswood Plywood
937
2581
Information
      As a small slate coaster stand to showcase your work.Cut your own small stand with your favourite feature slate engraving Total of 9 sets of stand.
Instruction
1
Step1: Open the file and add on the settings
Preview
Preview

If you are using other models of xtool machine you may need to fill in on the easypanel. For 20w used 60% 10mm/s 1pass with air assist turn on.

The file consist of 9 sets of small stands. If you required only 1 set just turn off the output in easypanel.

 

2
Step2: Assemble just slot 2 parts together.
Preview

2 parts of each parts that need to be slotted together to make up the stand.

3
Step3: Adding adhesive if required.
Preview
Preview

After slotting 2 parts together you may add a dap of adhesive to prevent from dislodging.

Comments
Remixes
xTool Supplies Used in This Template
xTool M1
xTool M1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC