Report
![[Laser cut and engrave] Boston Sports Flask](https://image-res.xtool.com/ali-res/community/making/d9b5ff2d-38f1-4f48-a902-505b4fea6688.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Boston Sports Flask
InstructionApplication scenario
Laser (30min)
Machine & module
xTool M1
10WMaterial used
Metal Flask
1434
Information
Laser Engraved Metal Flask
Instruction
1
Step1
- Remove the baseplate to your M1 Machine
- Place flask in center of area
- Set machine to "Open Plane"
- Set machine to "Metal Business Card"
- Use "Auto Measure"
- Add image to the center of the flask and set for engrave (I find that basic black and white are best for high contrast)
2
Step2
- Use framing tool to ensure that your image is on the flask and nothing is off the metal area
3
Step3
- Sent the project to the Machine
4
Step4
- It has taken roughly 20-30 minutes for each of my designs so far.
- Since you are using the machine without the baseplate, I would not leave unattended incase the image extends past the flask and onto the desk.
5
Step5
- Once complete, use a paper towel and some rubbing alcohol to polish the flask
- Wash with soap and water before use.
6
Step6
Comments