• Create your design 
  • This was created in a different program and I imported it .
• Create a 11.5" x 11.5" diameter
• Clean up an SVG that needs to be cleaned up. Like the beer mug for instance. 
  • There's a lot of unnecessary objects that can be delete and need to be united.  
  • Delete some of the inner nodes so that insides of the mug do not cut. 
• Arrange your objects on the board.
  • Select all the objects “copy and paste”
  • Make sure the objects on the board are scored and the others are set to cut

Double check all your material settings and automeasure your material.

• I used paint pens for this projects since most of the objects were small enough. 
• I also used craft tweezers to set some of the smaller pieces into the smaller slots of the beer mug.
• The scored lines will make it easier for all your objects to be glued to the board.