Hello Summer Hanger

NOTE: This design looks different from my finished design because when I went to reopen the file it wouldn't open and I had to redesign the whole project. 

• The design was created in another program.
  • Once I pulled the design in it was too complex for cutting so we need to clean it up.
  • Start by deleting anything anything that you may not want in your final design or anything complex.
• Create your backer board. 11.5" x 11.5" diameter circle was used in this design.
• Start placing your objects on the your board. Sizing and resizing to your liking.
• I needed sand and water to conform to the diameter so I had to use the  “unite at overlap” function.

Before sending to the laser make sure you auto measure you material!

• Paint your project accordingly and glue objects within the scored lines. 
• Grab some rope, ribbon, etc and hang it up!