Jewelry hanger tree
Instruction
This decoration allows you to hang jewelry. Would be a great way to display favorite pieces or a place to store them while showering. Could also be used simply as a decoration in the home.
After downloading the design file double check the settings to work best for your machine. The settings I used worked well on my D1 pro 20w. I like to engrave deeply so that detail is not lost during the sanding process. Once you have checked the settings proceed to run the machine.
After the design is done running, go ahead and sand any burn marks off of the pieces with the exception on the tree piece. It is fragile, and is likely to break if sanded. Next pick a desired stain and apply it to the pieces. Allow to dry.
Find the back panel and middle panel pictured above. Apply glue to the middle panel then place it on the back panel so that the holes from both panels are lined up. refer to the photo above.
Apply glue to the middle panel then place the top panel onto it. Refer to photo for orientation.
Apply glue to tab and the side of the narrow rectangular piece and place it into the slot on the top panel. Then make sure that it is square and allow for it to dry. (this will aid in gluing the tree piece in the next step.
Once the glue has dried from the previous step, take the tree out. Apply glue to the tab and side of the narrow rectangle piece. Place the tree onto the rectangular piece. Make sure that it is in the proper orientation. The top of the panel part is where the mounting holes are. Allow for it to dry, then apply a finish if desired. Enjoy!