HomeTemplatesTools & Special MaterialsGadgets
tpleo54
Report
[Laser cut and engrave] wood caliper
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] wood caliper
[Laser cut and engrave] wood caliper

wood caliper

Instruction
Caliper_V3_Full.xcs
Caliper_V3_Full
.xcs
Application scenario
Laser
Machine & module
xTool S1
40W
Compatibles · 11
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
424
2667

Instruction

1

Step1: lay out your design

wood caliper instruction: step 1 - lay out your design
Preview

lay out your design and set your power and speed. The red arrow in the drawing indicates the line where the measurements are read.

2

Step2: Score and cut

score and cut using the settings for your machine

3

Step3: assemble

wood caliper instruction: step 3 - assemble
Preview

Dry fit the parts before gluing. The holes are for bolting together if you prefer to do that instead of using glue. 

4

Step4: Sand if needed

wood caliper instruction: step 4 - Sand if needed
Preview
wood caliper instruction: step 4 - Sand if needed
Preview

Before gluing the parts together make sure it slides easily. If it doesn't then sand lightly.

Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC-SA