HomeTemplatesDecorHome DecorShelves & Holders
Drew's Den
Report
[Laser cut and engrave] Custom loofah
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Custom loofah
[Laser cut and engrave] Custom loofah
[Laser cut and engrave] Custom loofah
[Laser cut and engrave] Custom loofah

Custom loofah

Instruction
Scrub off stress.xcs
Scrub off stress
.xcs
Application scenario
Laser (15min)
Machine & module
xTool S1
40W
Material used
loofah
11
482

Information

      This is a way to add a little bit of personalization to your loofah.

73/312

Instruction

1

Step1: Design 1

Custom loofah instruction: step 1 - Design 1
Preview
Custom loofah instruction: step 1 - Design 1
Preview

This design is simple: create a box the size of your loaf and then fill it with your text.

2

Step2: Design 2

Custom loofah instruction: step 2 - Design 2
Preview
Custom loofah instruction: step 2 - Design 2
Preview

Now, you will use the process on curved material and map out your loofah handle. This will take some time, but it is worth it.

3

Step3: Material

Custom loofah instruction: step 3 - Material
Preview

For this, I used a wooden loofah from Walmart. Just make sure that your loofah is wooden and not made of another material like plastic.

4

Step4: Laser time

Custom loofah instruction: step 4 - Laser time
Preview

Now it's time to use the laser. This process is quite slow because it has a maximum speed of 30. I used a power setting of 7, but you may need to adjust the settings if you have a lower power S1. And don't forget to wear your laser-safe glasses.

5

Step5: You're Done

Custom loofah instruction: step 5 - You're Done
Preview

Your done with your loofah good job.

Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1

License

CC BY-NC-SA