Koozie

Information

      I remixed to move all the individual items closer together, used Lightburn to remove duplicate lines. then I brought it back to XCS and lasered image and cut. once cut, I used masking tape to remove all sticks together at same time and flip over. Once flipped over, I used the soft side of a Velcro set and place three strips across the whole thing. Once velcro applied, I used the base plate like a wheel and rolled the sides together on the base. Once complete, applied the top ring, applied heat glue gun around underside of base and underside of the top ring. U sued old shoelaces to apply a tight loop around base and tope to hold together until glue set.