IB3
Report

Funny Key hanger

Instruction
Key hanger Where the F.xcs
Key hanger Where the F
.xcs
Application scenario
Laser (40min)
Machine & module
xTool D1 Pro
20W
Compatibles · 10
Material used
3mm Basswood Plywood
80
761
Information
      This key hanger will keep your keys organized and safe. This was a fun project to work on. Relatively easy to make. I use mine for keys that I don't carry on me. this way the wood key chains wont break from everyday use. 
    
Instruction
1
Step1: download file, adjust settings, and run
Preview

My settings are based on what I have found to work best on my D1 pro 20w. I have the machine engrave deeply so that detail is not lost when sanding.  To make things easier I have engraved orientational directions on the design so that there is a number and an idea of what direction is the top of the three panels. Make sure to either take a picture or note of these before starting the assembly.

2
Step2: Sand and stain
Preview

Once the piece is done running go ahead and sand any burn marks off. Be careful not to oversand the pieces. Then choose a stain you would like and allow it to dry.  For mine I chose a light stain on the panels and a darker stain on the keys to give it a little contrast. 

3
Step3: Glue the three panels together
Preview
Preview

Taking note of the orientation of the panels, apply glue to one side of panel 2. Then place panel 2 onto panel 3.  Then take panel 1 look at where it will come into contact with panel two and apply glue to those areas. place it on panel 2. Next clamp them on a flat surface. Wipe any glue that squeezes out and allow it to dry.  Once it is dry you are ready to hang it up and start organizing your keys. Enjoy!

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro
3mm Basswood Plywood
3mm Basswood Plywood