Report
![[Laser cut and engrave] Cork Car Coasters](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/f25d64db-9774-43ea-922f-c88d175395e6?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Cork Car Coasters
Instructionpattern_cork_coasters
.xcs
Application scenario
Laser (45min)
Machine & module
xTool M1
10WMaterial used
cork
Cork Desk Pad
26
490
Information
Tired of you drinks sweating with condensation and it spilling down your car's console? These cork coasters not only help with that problem but you can also engrave them to fit your personality
Instruction
1
Step1: Prep Work
Preview
Preview
- Use your digital calipers to measure the diameter of the coaster.
- Also I measured the smaller hole so I could account for that in my design.
2
Step2: Designing the Coaster
Preview
Preview
- Create a circle that is 2.75" x 2.75"
- use the ration unlock to the get these exact dimensions (located on the right side panel next to the measurements)
- Create another smaller circle .46" x .46" (again you will use the lock ratio)
- On the left side panel, use the basic shapes icon and go it patterns
- Select the pattern or patterns you want to use for your project.
- Drag the pattern on top of the circle
- Select them both and click “unite at overlap” on the left side panel.
3
Step3: Laser Work
Preview
Preview
- Select your patterns and set the your engrave settings
4
Step4: Finished!
Preview
Preview
- Once down you can put them in your vehicle and enjoy your new car coasters!
Comments
