XTOOL RA2 wooden storage box

All descriptive words for parts had output turned off. Had honeycomb installed for all parts. These were all done on M1 Ultra 10W and settings listed worked for me and these may need to be adjusted depending on machine used and material used. All was done on 3mm Basswood. 

Bottom of drawer acted as bottom plate for inside organizer and outside box helps with support for the weight. Just glue organizer into bottom of drawer after drawer is put together for easier line up, left a little play to make it easier to install. Glue all small boxes in there place and you are done. 

The first 4 canvas patterns are the parts needed to assemble outside box and 3 smaller boxes to be used on organizer tray later. Using a small hammer and scrap piece of wood, assemble the sides and back of box leaving all the smooth sides facing forward for drawer. I did not need glue as the joints are very tight.

Last 4 Canvas's have the parts needed to assemble the drawer and the organizer tray to go into drawer. Using hammer and scrap piece of wood, assemble the drawers 4 sides to bottom making sure front engraved side is facing forward side.

Glue organizer tray cut out earlier into bottom of drawer and assemble the 3 small boxes and glue into spots in tray. The middle spot is for screwdriver box and other 2 are on front of drawer. The drawer box is complete and hope you enjoy.