Report

[Laser cut and engrave] Engraved Santa Claus with leaves on a wooden plaque — Project made with xTool M1 Ultra,xTool S1 machine for Christmas.

Gravure d'un père Noël en relief

Instruction

le pere noel dans so_1_850649

.png

Application scenario

Laser processing (45min)

Machine & module

xTool M1 Ultra

10W

xTool S1

20W

Material used

Rock Stone

1292

Information

      [Style] Low relief
[Prompt] Santa Claus in his sleigh who goes to deliver the presents and who passes in front of a full moon with falling snow (it didn't really give me what I wanted but I found this design very beautiful)

Instruction

Step1

Preview

Upload the image

to XCS resize the image keeping the padlock closed to keep the proportionality of the pattern.

Place your support in the laser.

Do the automatic measurement and then the registration of the material.

Choose the desired parameters if xTool materials please refer to their parameter near save. For my part, I put 50% of power and 200 of line speed 100 in grayscale mode.

For slate, acrylic remember to activate the Inverted mode in the XCS options

Start engraving and wait for the end to see the result

Comments