Natural Color PEEK

Wear goggles that match the wavelength of the light source

When operating with open covers or using open-type devices, be sure to wear laser goggles that match the wavelength of the light source. Different light sources (blue light/infrared/CO2/UV) have different wavelengths; please pay attention to whether the wavelength protected by the goggles matches the laser;

After processing is complete, wait until the smoke is cleared before opening the lid to retrieve the part

After processing, do not open the lid immediately. Wait for the smoke exhaust system to run for 10~30 seconds and after the smoke inside the chamber is completely removed before removing the part. Opening the lid immediately will allow unvented smoke or odorous gases to flow directly into the operator's face. Ensure good ventilation and wear a protective mask if necessary.

Processing chlorine-containing materials is prohibited

It is strictly forbidden to process chlorine-containing materials such as PVC, artificial leather, or veneer soft rubber. Laser burning releases highly corrosive toxic gases such as hydrogen chloride, endangering human health and corroding guide rails, lenses, and circuit boards. When unsure about the material, first conduct a small-area test and observe the smell.

Before cutting, make sure the fire extinguishing equipment is in place

Before starting cutting, place the CO2 fire extinguisher or blanket within one meter of the equipment in a location that is easily accessible. Combustible materials such as wood and acrylic carry the risk of ignition.

Pay attention to odor prevention during processing

Materials such as leather, rubber, and silicone produce noticeable odors; ensure good ventilation and wear protective masks if necessary.

Handling when a flame alarm appears

If a flame alarm is triggered when processing flammable materials such as plywood, acrylic, or polyester mesh: stop processing immediately, maintain smoke exhaust operation, and only open the lid after confirming there is no open flame. Do not open the lid directly to promote ignition.

Prevent high-temperature burns after processing

Freshly processed materials and cuts are very hot; please wait for cooling or wear gloves to pick up parts; do not touch them directly.