Laser Engraved Mama Bear Keychain

Pictures have written instructions in them.

• Bear Tracing
  • You can bring a copy of the bear you would like to use. 
  • Click “Trace Image” on the right hand panel
  • You can play with the sliders on the right side to get clear, smooth blue lines over you image. The smoother and clearer the better.

Picutres have written instructions in them.

• Photo #3 and Photo #4 - Edit Nodes
  • To really make this image your own you can edit and delete some nodes. 
  • In this project, I didn't like the hump on the bears back to I deleted the noded.
    • Click “Edit node” on the right side panel
    • Click on a node and it will turn a solid color.
    • Press delete on your keyboard and it will delete that selected node
    • You can do this for all the nodes you want to delete.
    • If you just want to move on just click and drag.

• Add a small circle from the left side panel for the keyring.
  • Place somewhere on the bears body. For this project I placed it on the leg to the ring is easy to get on and off. 

• Click on the “T” on the left side panel to add the text “mama”

Make sure the bear and the small circle are both set to cut

Make sure the text is set to “engrave”

I used a prestained board I had from a previous project. You can keep this natural, stain or paint it. 

• Grab your pliers, keychain and a pretty tassel. ( This set was bought from amazon.)
• Now use your pliers to open the ring, loop the bear through.
• And then open another ring and loop the tassel through.
• And you're all done!