Report

[Laser cut and engrave] Laser Engraved Color Test Calibration Card for 3D Printing — Project made with xTool F2 Ultra machine for Laser cut and engrave.

Stainless Steel Dogtag MOPA Color Test Grid | Speed * KHZ

Instruction

ColorfulDogtagkhz

.xcs

Application scenario

Laser processing

Machine & module

xTool F2 Ultra

40W, 60W

Compatible xTool Machine

F2 Ultra UV

F1 Ultra

20W

5W, 10W

D1 Pro

2W, 40W

2W, 10W

2W, 10W, 20W, 40W

F2 Ultra (Single)

60W

Material used

Stainless Steel Military Pendant (Keychain, Necklace)

1258

10278

Information

      
Make sure you defocus the Laser, so the heating is more even, and the finish has less of an influence on the outcome.

Instruction

Step1: Load the XCS

Load the XCS and go through the usual focusing and alignment,
then make sure to defocus the laser by adding 0,3mm to your Z height.
You may wanna change the processing mode to “by Layer” to use the more spread out pattern I made using the different layers, to have heat be more predictable.

Comments