reuben_marcus

Report

[Laser cut and engrave] A Color American Flag with Border - Version #2 — Project made with xTool F2 Ultra machine for Laser cut and engrave.

A Color American Flag with Border - Version #2

Instruction

ColorAmericanFlag_V2a

.xcs

Application scenario

Laser processing (63min)

Machine & module

xTool F2 Ultra

60W

Material used

304 Stainless Steel Metal Business Cards 3.4 x 2.1 inch Sublimation Blank Steel Card

1185

Information

      Using the xTool F2 Ultra, the project uses C-Engrave and an ".8mm 304 stainless steel card" from Amazon to produce a Color American Flag - this project is a little more advanced than my first Color American Flag only because I added a few subtle colors and I'm doing the "clean-up" prior and before all colors are c-engraved.

Instruction

Step1

Color American Flag with Border Version #2

Here is the project information and further instructions:

IMPORTANT - Make sure to remove the plastic from both sides of the .8mm 304 stainless steel cards.

1 - Open project.
2 - Place your .8mm 304 stainless steel card straight and close to center of work-bed.
3 - Focus manually using the up and down arrows on your F2U console. If your processing your stainless steel card directly on the stock work-bed, the focus should be around 2-3mm, this will vary, but ensure to focus as precisely as possible.
4 - Initially line-up your material with F2U camera.
5 - Finally line-up with Framing. Hit framing button (square or outline) in xTool Studio, then turn off framing.
6 - Hit Process in xTool Studio.
7 - GO! Press the start button on your F2U console.

Project takes ~1 hour.

Stay blessed, good luck and please use this project in good health!
Please LIKE and post your results here and social media.

Comments