Report
![[Laser cut and engrave] How to engrave wooden hangers](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/26a206ee-0021-4998-8d39-3dfc0657f77e?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] How to engrave wooden hangers](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
How to engrave wooden hangers
Instructionwooden_hangers
.xcs
Application scenario
Laser (10min)
Machine & module
xTool M1
10WCompatibles · 12
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
186
2323
Information
Want to laser engrave wooden hangers but don't know where to start. This How To will get you lasering wooden hangers like a pro!
The font I used can be downloaded from creative fabrica its called Willowshine.
Instruction
1
Step1: Prepping
Preview
Preview
- place the hanger in the laser just right under the red laser light.
- shut the top and auto measure your material
- Open the laser back up and move the hanger to the top of your honeycomb or base plate.
2
Step2: Design
Preview
Preview
- Once I have my material inside I then that as a guide to where I want my text to go.
- size your text to your liking. you can even use the arching feature to make it arch if you like.
3
Step3: Laser
Preview
- Because this is a small surface area, we want to make sure its exactly where we want it.
- Use the framing feature to see exactly where the text will be engraved before you send it to the laser.
- Once done check your settings!
- Make sure your text is set to “engrave”
- I used 45 power and 70 speed and 200 lines
- One this is done lasering you can clean it up with a baby wipe or some soap and water.
Comments
