Laser Cut Wooden Teddy Bear Ornament/Keychain Holding Heart

1.    I used 3mm basswood sheets that measured 12x12 or 12x24 inches and placed one in the center of my P2S for each layer. 

2.    In the software, I positioned the main design on top of the basswood centering all layers after I refreshed the background. 

3.    Click on the design pieces and confirm that the cut is 60/27/1 and score is set to 10/200/1. 

4.    Click on Preview to confirm the cut, and score is correct. 

1.    Place one 3mm sheet in the center of the machine on slats. 

2.    Hit Refresh Background 

3.    Move Layer 1 to center of wood. Confirm all pieces are centered on the basswood. (Can do the close-up image if you choose.) 

4.    Press Aimed-Measure, then move the blue box cursor over the wood surface and click anywhere on the wood cutting area to get an accurate read. 

5.    Click the OUTPUT to on. 

6.    Click the Process button on the bottom right of the screen. 

7.    Click preview in bottom right to confirm 

8.    A preview will be shown. Click the Start button (top right) to send it to the machine. Press the button on the P2S machine to start.  

9.    Watch since material is Flammable. 1

1. Remove from machine
2. Clean char
3. 3 Paint