Personalized Etched Wine Glass.

The wine glass is from Ikea's typical pack of 6 we use to buy time to time to replace the accidentally broken ones.

I use a water based ink spray, that can be cleaned afterwards with warm water (and a bit of patience…). I get a pretty wide and uniform coat with a very short "push"

I used the same settings for the name and the border: 70% power, 50 mm/sec and 100 lines/cm. The image of the crossed legs is made with 1000 micro-sec, 70% power and 500 DPI. (Should be all at the xcs file)

It took about 11 minutes for the F2 to carve the full design.

Hope you enjoy it!