Report

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints — Project made with M1 Ultra machine for Laser cut and engrave.

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints — Project made with M1 Ultra machine for Laser cut and engrave.

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints — Project made with M1 Ultra machine for Laser cut and engrave.

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints

[Laser cut and engrave] Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints

Laser Engraved Wooden Dog Themed Bookmark with Books and Paw Prints

Instruction

Black Lab Bookmark.xcs

Black Lab Bookmark

.xcs

Application scenario

Laser processing

Machine & module

xTool M1 Ultra

10W

Compatible xTool Machine

P3

F2

F2 Ultra UV

F2 Ultra

F1

S1

P2S

P2

M1

D1 Pro

D1

M2

Accessories

xTool M1 Riser Base with Honeycomb Panel

xTool M1 Air Assist Set

Material used

1/8"(3mm) Basswood Plywood

gift

20

828

Information

      This project provides a simple and original instruction for engraving and cutting wooden bookmarks using the xTool M1 Ultra (10W diode laser).
The instructions are based on my own setup and testing, focusing on practical use, machine configuration, and common checks before running the job. The bookmark size can be adjusted freely to match personal preference or project needs.
Please note that the default settings are optimized for basswood plywood. If you choose a different material, the laser settings will need to be adjusted accordingly, and results may vary if parameters are not recalibrated.
Before starting, make sure the file includes separate Engrave and Cut operations, as the software may occasionally consolidate them automatically.

reading accessory

Instruction

1

Step1: Machine Set up

⚠️ Important:
If you change the material, the default settings included in this file will also need to be adjusted.
Using a different wood, MDF, or acrylic may result in poor or unsatisfactory results if the parameters are not recalibrated.

XCS may sometimes automatically consolidate operations.
Before running the job, verify that Engrave and Cut are still separated, and manually reassign them if needed.

Power ON the xTool M1 Ultra
Install the honeycomb bed
Place the wood sheet on the honeycomb
Secure material using magnets, ensuring flatness

2

Step2

Open xTool Creative Space (XCS)
Import the bookmark file
Position the design within the material area
Perform Auto Focus
Use Frame to confirm alignment

3

Step3

Acceptance Criteria

Engraving is clear and legible
Consistent engraving depth
No excessive burn marks
Clean cut-through edges
Bookmark dimensions per design

4

Step4: Finishing & Storage

FINISHING (IF APPLICABLE)

Light edge sanding (grit 220–320)

Clean engraving residue

Optional sealing or oil finish

STORAGE

Store bookmarks flat

Protect from moisture and bending

Avoid stacking without separators

Comments

Remixes

License

This work contains AI-generated content.

You may also like

The Dog Paw Mandala

dog paw split mandala