"Stackable Coffee Organizers w/Tray" Laser Cut and Engraved

I used 1/8"(3mm) Bass Plywood for the Pod Holders (Drawers)

I used 3/16"(4.5mm) Birch Plywood for the Outside Box (Local Purchase) Note:  It was listed as ¼ Plywood but is realy 3/16" or .17"

1.  Again I used 1/8"(3mm) Bass Plywood (2 - 12"x12" sheets)
2. Setting for my cuts are shown in the above images

1.  For the outside boxes I used the 3/16" Plywood for the additional strength
2.  Again the setting for the cuts are shown in the above images

1.  All the above items were created using the 3/16" Birch Plywood
2.   All Setting for cutting and engraving are shown in the above images

1.  Layout, glue tabs and lightly clamp
2.   Note that the front side has a longer slot (cutout) to slide the handle through.

1.  Layout, glue tabs and lightly clamp
2.   Ensure the sides are placed with the tabs to the rear

1.  Layout the tray, glue tabs and lightly clamp
2.  Add the rails to support the stackable containers
3.  Add the front tabs
4.  Final Note:  This project can be modified to meet your needs or wishes
5.   Have Fun….