Graduation Gift Tag

• Start by inserting two shapes
  • a rectangle
  • hexagon
• Overlap them at the top of the see the second photo for reference
  • Unite them together on the right side panel
• Now we need to clean it up so click on edit nodes on the right side panel
  • Click on the one that is sticking out the most and hit delete on your keyboard
• Add a small circle and place at the top. This is where our ribbon or string will go through.
  • You can use .25" x .25"
  • Make sure you align the circle horizontal center 
  • Select both objects and group them together
• Now add the text you would like in the font you want to use
  • Dont forget to align horizontally center

• Make sure all items are set to cut before sending to the laser

You may notice my photos of the design are different from the finished product. After I cut this I noticed some of the cursive writing was too brittle so I went back and redid it to a better font that would cut better. 

You can paint and glue down your pieces to the backer board.

For the photos I added a small tassel but you can also add some string and ribbon to pair with the tassel if tying to a gift.