Laser Engraved Coffee Bar Sign with Rope Accent

   Remodeled my kitchen with new backsplash, new counter tops, new floor. While doing the backsplash I came up with the idea of making larger tiles with sayings on them to go around the counter in a few areas. Bought a box of 10 tiles and black matte paint.

  Came home sprayed the tiles with three coats. Ensured they were dry and put the tile into XTool. Once on XTool Design Started just uploading various pics and editing until I had enough for the sign. 

Watch the process preview to ensure it is how you want. The tile is about a ¼" thick so after every tile change realign, and re-auto measure.

  For this one took three passes and it was finished to my liking. As you go along you will see for yours if at one pass it does not look as brite, and clean lines run another pass. Once finished dust off if needed with soft dust brush.

Grab some twine and wrap each end tying a tight knot, add another piece to connect to each side again with a tight not. Your ready to hang the sign up.

                                                                                                                By Gi