Report
![[Laser cut and engrave] Laser Engraved Wooden Ruler With Quote One Ruler To Rule Them All](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/5128bd3a-2986-4cae-880b-34425ac189de.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Laser Engraved Wooden Ruler With Quote One Ruler To Rule Them All](data:image/png;base64,iVBORw0KGgoAAAANSUhEUgAAAAoAAAAKCAYAAACNMs+9AAAAAXNSR0IArs4c6QAAABdJREFUKFNjZCASMBKpjmFUId6QIjp4AAppAAuXjCs4AAAAAElFTkSuQmCC)
![[Laser cut and engrave] Laser Engraved Wooden Ruler With Quote One Ruler To Rule Them All](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/5128bd3a-2986-4cae-880b-34425ac189de.jpg?x-oss-process=image/resize,w_200,h_150,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Laser Engraved Wooden Ruler With Quote One Ruler To Rule Them All](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/ad34ced2-a94e-493e-b046-902dd7d0e9fb.jpeg?x-oss-process=image/resize,w_200,h_150,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Laser Engraved Wooden Ruler With Quote One Ruler To Rule Them All](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/6ee98b0d-8a5c-49ff-83e4-e8b2c1a8039c.jpeg?x-oss-process=image/resize,w_200,h_150,limit_0/interlace,1/format,webp/auto-orient,1)
The One Ruler To Rule Them All
Instruction
ORTRTA
.xcs
Application scenario
Laser processing (10min)
Machine & module
xTool P2S
55WCompatibles · 12
Material used
1/8"(3mm) Birch Plywood
13
Information
This is a 12"/30cm ruler, marked at each 1/16th inch and 1 mm increment. On the back (Blue stuff), it has conversions for each 1/8th inch increment 1/8 - 1" and each 5 mm increment 5 - 100 mm between inches and millimeters. Yes it's unnecessary. Yes you should still make it because why not.
Instruction
1
Step1: Engrave and cut the front.
Preview
Run the yellow, red, and black layers to engrave the front and cut out the ruler.
IMPORTANT: DO NOT MOVE THE MATERIAL WHEN REMOVING THE RULER!!! ANCHOR IT DOWN!!!
2
Step2: Engrave the back (Optional, but recommended)
Preview
Flip the One Ruler over so that the non-engraved side is facing up now. Place the ruler back into the same hole it came out of with the blank side up, then run the blue layer to engrave the back.
Note: It may not look like it lines up if you take a new picture. Trust me, it will line up properly. Don't try to move it to line it up.
Comments
