Report

[Laser cut and engrave] Laser Engraved Wooden Coaster with Sloth and Heart Design — Project made with xTool S1 machine for Laser cut and engrave.

Sloth Frame

Instruction

sloth frame

.xcs

Application scenario

Laser processing (37min)

Machine & module

xTool S1

20W

Compatibles · 10

Material used

1/8"(3mm) Red Felt

Information

      This is on a 12" x 12" board the actual project size is 8" x 8". The heart size were you would put a photo is 2.5" x 2.5" perfect for school photo or any photo. Cut a piece of felt a tad smaller than frame to cover. Glue corners with craft glue, tight, now you can easily slide a photo in and out. Or glue all sides to permanently keep photo in place. Or you can use the smaller heart cut out and glue that on as in the above photo.

Instruction

Step1: Sloth Frame

Preview

Cut a piece of felt a tad smaller than frame to cover. Glue corners with craft glue, tight, now you can easily slide a photo in and out. Or glue all sides to permanently keep photo in place. Or you can use the smaller heart cut out and glue that on as in the above photo.

Comments