knbberghuis

Report

[Laser cut and engrave] Laser Cut Wooden Christmas Gift Box with Snowflake Decorations — Project made with xTool S1 machine for Laser cut and engrave.

Small Christmas snowflake box with Ribbon

Christmas box with ribbon 5X5

.xcs

Application scenario

Laser processing (60min)

Machine & module

xTool S1

40W

Compatibles · 13

Material used

1/8"(3mm) Basswood Plywood

169

Information

      This is my first submission, so thank you for your patience if anything needs adjusting.

I created this design using the Smart Box Generator as a starting point and then customized and improved it. Please note that the preview image differs slightly from the uploaded files, as I made a few refinements after the photo was taken.

When making the ribbon, results may vary depending on your machine. Ribbon can be tricky, so be careful to cut cleanly rather than burn. On my S1, I found that a setting of 95 / 10 worked best.

Assembly Instructions:

Use the C-shaped pieces in the center to form the ribbon holder.

The four small pegs are used to secure the ends of the ribbons.

If you have any questions or suggestions, I’d love to hear your feedback. Enjoy!

Comments