pavel.ruzicka

Report

[Laser cut and engrave] Laser Engraved Merry Christmas Brass Coin — Project made with xTool F2 Ultra machine for Christmas.

Laser Engraved Merry Christmas Brass Coin

2025 Christmas Contest

Instruction

christmas_coin

.xcs

Application scenario

Laser processing

Machine & module

xTool F2 Ultra

40W, 60W

Compatibles · 9

Material used

Brass

Information

      Brass coin with a Christmas theme and an inscription in two languages (Czech and English). Can be used as a decoration or a gift.

Instruction

Step1: Prerequisites

For brass embossing you need to use a fiber laser like F1 Ultra or F2 Ultra.
F2 Ultra was used in this project.

Step2: Coin placement

Place the coin approximately in the center of the area so that it can be focused.
After focusing, move the coin as close to the back as possible, near the exhaust fan.

Step3: Embossing

You can use my project settings for processing on the F2 Ultra. It takes about an hour to process one coin. If you are using the F1 Ultra, you must use the settings appropriate for that machine. You can be inspired by my other coin embossing projects. On the F1 Ultra, one coin takes about four to five hours.

Step4: Cleaning and polishing

For cleaning, you can use the laser on which the coin was created. For F2 Ultra, my project already includes continuous cleaning of the coin surface. For F1 Ultra, you can again be inspired by my older coins. You need to create a cleaning layer and run it after embossing.
For mechanical cleaning, you can use a wire brush, steel wool or one of the electric compact multi tools. I found a magnetic tumbler to work well.

Comments