Report
![[Laser cut and engrave] Rust Removal](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/3816ffea-d5ae-4d50-b9e8-08cd41364747?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Rust Removal](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
Rust Removal
Instructionrust
.xcs
Application scenario
Laser (10min)
Machine & module
xTool F1
2WCompatibles · 10
Material used
18K Gold Plated Rectangle Pendant
100
1750
Instruction
1
Step1: Clean
Preview
First, remove any excess rust. I used a scourer under the sink.
Then, completely dry with a paper towel.
Before above, after below.
2
Step2: Preparation
Preview
Measure the length and width of the tool then change the square size in xTool creative space file.
Check the size is correct by framing.
3
Step3: Engrave
Preview
90% of the surface-level rust has been removed from just one pass. More scouring of the most rusted spots would have ensured a more even finish.
Before above, after below.
Comments
