Gena

Report

[Laser cut and engrave] Welcome Sign with Dog Theme — Project made with xTool P2 machine for Laser cut and engrave.

Welcome Sign with Dog Theme

Instruction

Dog Print Welcome Sign with Dog Print March 2024

.xcs

Application scenario

Laser (60min)

Machine & module

xTool P2

55W

Material used

Transparent Acrylic

Birch Plywood

1/8"(3mm) MDF Board

3mm Basswood Plywood

296

1966

Information

      Everyone likes dogs and I made this to sell as a front door hanger.

Instruction

Step1: Cut wood pieces for layer #2

Preview

I used one piece of 12 X 20 ¼" birch plywood to cut the wood pieces to fit on a 16" MDF round.

Step2: Cut "Welcome" out of Acrylic in reverse

Preview

I used acrylic for “welcome” because I like the way acrylic shines but wood could easily be used. I cut acrylic in reverse and keep the top layer of the protective paper attached so that no burn flashes show. I used an Exacto blade to start the peel to get the paper off of the front of the acrylic.

Note: The orange circles in my image are pieces of junk jewelry to help me align my image since my material was black. I took them out before the cut.