Flower Basket

Make concentric circles increasing by the width you want the layers to be. You can make as many as you want. Make two of the same size for the innermost ring.

Make two half circles sightly larger than your outermost circles. The subtract them so that you get a half circle bar. Repeat to make a handle.

Make small rectangle the size of the width of your material being used. The length does not matter. Place them on either side of the circles and subtract. I like to use the grid lines and the next size circles to make sure I keep it even. Repeat this step for each circle. If you made a handle make 4 on the outermost ring.

You can also make duplicates of the outtermost depending on how tall you want it.

Its easiest to do all “slots” at once and then use the subtract function.

Take one of the “slots” and place in the middle of the duplicate smallest ring to make a base.

Place to get the most optimal room and decorate as needed. Make sure all items besides the decorations are set to cut. The benefit of the layout is you can optimize space bay layering the rings.

There will be little jutting pieces from the slots, these can be cut off or left.