![[Laser cut and engrave] Engraved Vitruvian Man Brass Coin - Embossage pièce laiton homme vitruve](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/7c07873f-eaf2-413e-9947-6675748fe577.png)
Engraved Vitruvian Man Brass Coin - Embossage pièce laiton homme vitruve
Atomm Featured
Instruction
Information
As an artist, I really wanted to have this piece in my studio as a reminder of Leonardo da Vinci's masterpiece, the Vitruvian Man—a must-have!
This piece can only be made with the F1 Ultra (coming soon with the F2 Ultra as well).
---
En tant qu'artiste je voulais vraiment avoir cette pièce à l'atelier en souvenir du chef d'oeuvre de Leonard de Vinci, l'homme de vitruve, un incontournable !
Pièce réalisable uniquement avec la F1 Ultra (prochainement avec la F2 Ultra également)
Instruction
Step1
Place your part in the machine and make sure to focus it properly so that your laser is set to the correct distance.
To do this, make sure that the red dot overlaps the blue dot by moving the laser up or down.
---
Place your part in the machine and make sure to focus your laser at the right distance.
To do this, make sure that the red dot overlaps the blue dot by raising or lowering the laser.
Step2
Open the file in depthmap and position it on your part.Set
the parameters as in the photo:
Mode: embossing
Laser type: fiber
Number of layers: 256
Power: 100%
Speed: 500
Pass: 1
Lines: 300
Angle: 30
Frequency: 30
Go down to z axis:
on All N layers: 2
N mm: 0.01
Start the process: 3h30 of engraving
---
Open the file in dephtmap and position it on your part.
Adjust the parameters as in the photo:
Mode: embossing
Laser type: fiber
Number of layers: 256
Power: 100%
Speed: 500
Pass: 1
Lines: 300
Angle: 30
Frequency: 30
Go down to the z-axis: on
All N layers: 2
N mm: 0.01
Start the process: 3h30 of engraving
Step3
Wash and scrub the part well under water with soap
--
Laver et bien frotter la pièce sous l'eau avec du savon
Step4
This step is optional.
I dipped the piece in a metal burnisher to give it a more "old" and patinated look.
Leave it in the liquid for a few seconds until the piece turns black.
Rub with a green sponge under water to remove the black and reveal the details.
Stop when you like the result.
---
This step is optional.
I immersed the piece in a metal burnisher to give it an "old" and patinated look.
Leave for a few seconds in the liquid until the piece turns black.
Rub with a green sponge under water to remove the black and reveal the details.
Stop when you like the result.
Step5
Finish by rubbing with steel wool to polish and shine.
You can also use a dremel to polish even more.
Admire!
---
Finir en frottant avec une laine d'acier afin de polir et faire briller.
Vous pouvez aussi utiliser une dremel pour polir encore plus.
Admirez !
