HomeLaser&Cut ProjectsToolJig
wetherbeemike62
wetherbeemike62
Report
[Laser cut and engrave] Business card jig for the F1 slide extension
Project made with xTool F1 machine for Laser cut and engrave.
[Laser cut and engrave] Business card jig for the F1 slide extension
[Laser cut and engrave] Business card jig for the F1 slide extension

Business card jig for the F1 slide extension

Instruction
Business Card template blank.xcs
Business Card template blank
.xcs
Application scenario
Laser (60min)
Machine & module
xTool F1
Material used
Apple Green Stainless Steel Tumbler with Handle (24oz)
Birch Plywood
gift
690
5851

Information

      This template holds 6 business cards.  I made holes in the bottom board for easy out removal.  The bottom board and the top board are the same size.
Business
jig

Instruction

1

Step1: cut the bottom board my dimensions are slightly smaller than the extension and you should cut the red holes and the outer perimeter for the first cut

Make sure when cutting with the f1 that you stay off the edge of the wood or you will get a fire and the machine will shut down 

2

Step2: Cut the top board you should cut the outer perimeter and the inner squares and ignore the holes on this cut

This board makes batching business cards for the f1 a breeze I just finished 50 for a customer today!!!!

3

Step3: After cutting out both boards glue them together making sure they are exactly aligned to one another

make sure to remove any glue inside your card holes while it is soft as that is when it is the easiest.  I used a pocket knife with a pointed blade to remove small bits of glue.

Comments

Remixes