Report
![[Laser cut and engrave] Fall Gnome](https://image-res.xtool.com/ali-res/community/making/dd87bbe7-1eaf-42fe-ac73-40c35dfaaafa/tempImagedZApue.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Fall Gnome](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
Fall Gnome
Application scenario
Laser (90min)
Machine & module
xTool M1
Material used
1/8"(3mm) Basswood Plywood
2309
Information
I engraved the back of the board with a fall pattern of acorns and leaves. I then stained the board instead of painting so the engraving would show through. I got glued florals onto the back. I cut out a small paper rose pattern and rolled it and super glued it to his hat.
Comments
