Tumblers for Christmas

Information

      I engraved a number of designs into Reduce branded tumblers from Sam’s Club. The attached xcs file is intended for use on the xTool F1 with the RA 2 chuck. I set the start point midway through the handle. I created four “quarter blocks” to help with centering the design on the “front” of the tumbler assuming the person would hold it with the handle in their right hand. I used the 10w diode for the first pass (Setting 1) and the 2w IR laser for the second pass (Setting 2). I separated the two using different layers and set the Processing path to “By layer.”