Report
![[Laser cut and engrave] Gift Exchange Dice Game](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/91564317-dab7-4c56-ad8c-c1c28eeda927_Gift Exchange Game Board.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Gift Exchange Dice Game
Instruction
Gift Exchange 2023 Final in Groups
.xcs
Application scenario
Laser (120min)
Machine & module
xTool P2
55WMaterial used
1/4" Birch
Birch Plywood
236
3573
Information
I made this as a fun alternate to Dirty Santa for our family. We were originally going to play three rounds and changed it to five rounds. (We had Christmas early this year.)
Instruction
1
Step1: Pre-stain wood and let dry before processing
Preview
I usually wait 24 hours after I stain wood before processing. After processing I immediately take projects to the kitchen sink and wash under running water to get the residue off then towel dry.
2
Step2: Score, Engrave & Cut Base Layer then cut Top Layer for Frame
Preview
I rotated this project 90 degrees to get the maximum size in slats flat mode w/honeycomb and it was 11.25" wide by 13" high. I believe it took longer to process this way. Attempt #2 will be upright using conveyer so I can make it larger.
3
Step3: Spray with Clear Coat
Preview
My favorite spot to spray aerosol is on my trashcan! I bring it into the garage to let it dry completely.
4
Step4: Glue it together!
I use Starbond THICK from Amazon. It just takes one little dot per inch without leaving residue.
Comments
