jim.murr

Report

[Laser cut and engrave] Wooden handcrafted architectural model — Project made with xTool P2S machine for Laser cut and engrave.

Material Alignment Jig for P2S

Instruction

XYZ-FINAL

.xcs

Application scenario

Laser processing

Machine & module

xTool P2S

55W

Compatibles · 11

Material used

1/4"(6mm) Basswood Plywood

994

Information

      Perfectly square up material to the laser head. This jig needs to be used only when the  machine is off and the arm is free to move forward and back. The jig fits over the arm and just clears the slats or the honeycomb.

jig

Craft

Instruction

Step1

After cutting the pieces, dry fit everything together. I used wood glue and clamped the two 1-½" pieces to the 3 notched ‘L’ shaped pieces. To make sure the jig was square, I clamped a small triangle to insure the 90 dg angle, while the pieces dried. After, I removed the clamps and glued the 1" pieces and finally the two ‘L’ shaped pieces, re-clamped everything till dry.

Comments