Mushroom Plant Stake

My settings are just recommendations. I technically used 5.2 mm wood. Please be sure to use what settings work best for your materials and your machine. Running a test grid is always a safe bet. 

Process your shapes. The purple scored layer is optional. It’s only included to help guide you when aligning your pieces in later steps. 

Sand your pieces if needed and make sure they are wiped clean. 

Once your shapes have been processed & are clean. You’re ready to paint/stain. 

You can get creative with this step! Use whatever colors and methods of applying color are your favorite. 

I used a wood stain on the stake piece. I chose to paint the mushroom cap piece red, and the inside dots & stem piece white. 
 

Follow the directions on your chosen paint/stain method & allow to dry completely. 

Important note: if you plan on using these outdoors, then please make sure your stain/paint are suitable for outdoor use. 

Once your pieces are completely dry, you’re ready to begin assembling. 

You can choose to include the inner dot pieces from the mushroom cap, or leave it open. I included photos of both options laid out to show you what those choices look like. For my design, I used the inner dot pieces. 

Glue & clamp your mushroom pieces to the stake piece. 

Follow the instructions on your adhesive of choice. Allow to dry completely. 

I included a photo of the glue I use, I like it because it’s easy to wipe or sand off excess & it dries clear. I also like using a silicone brush to get glue onto smaller pieces and cuts without having a lot of excess glue. 

Important note: if you plan on using these outdoors, then please make sure your stain/paint are suitable for outdoor use. 

Once your pieces have been glued & clamped, and are completely dry…you’re all done! 

Now, just decide which of your plants, flower beds, or where in your landscaping you’d like to add some Whimsy with this Mushroom Plant Stake!