Steampunk skull

ID 40781
Instruction
Files
Original files
Author
1
Preview
Preview
Preview
Add Make Profile
Same design, different machine, material, or any improvement · Earn 50 Credits
Tips for a great Make Profile →
gift
80
1625

Information

      This is an engraving from digital design into a 3mm wood sheet. 
Two simple steps; engrave the file and cut the perimeter. All can be done in the same session. The machine used for these wall art piece was a XTool S1. The material was XTool basswood 3 mm sheet.
    

Instruction

1

Step1


Recommendations: place the material over a honeycomb panel for better cutting performance. Use the magnets to secure the material and set the air assist on auto. 

Start the process.

Comments

Remixes