Report
![[Laser cut and engrave] Wall vent with electrical outlet on a gray wall](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/6f85c585-9021-400c-89ea-85ab78c4c861?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Wall vent with electrical outlet on a gray wall](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
Air Vent
Instruction4x10vent
.xcs
Application scenario
Laser processing (25min)
Machine & module
xTool S1
20WMaterial used
3mm marble MDF
2 sided tape
9
355
Instruction
1
Step1: Designing
Preview
Preview
Preview
2 More images
- This project starts with a rectangle 11" x5" in size
- This rectangle has it's corners set to a small radius
- Once the outside is ready the vents are added
- This was done the same way by just adding thin rectangle and giving it radius corners.
- Then this was copied and pasted to be side by side with equal spacing from each end and the middle
- Once the first 2 vents were in place the grid array feature was used to create more venting holes
- With the amount selected to fill the area they were spaced out to be equal.
- After the entire vent was designed it was set to be cut and was sent to be processed.
- Once finished the new vent was cleaned off with a cloth and 2 sided tape was added to adhere to the wall.
Comments
