Flame Light

Place the front panel with the engraved eyes facing down. Insert the latch plate into the square holes of Board No.1 and Board No.2. Align it with the bottom of the front panel and then fix it with glue. 

Peel off the protective film on the surface of the acrylic board and set it aside for later use.

First, install the No.1 and No.2 acrylic boards, paying attention to the direction. Then, install the No.3 and No.4 wooden boards. Make sure that the bottoms are aligned and fix them with glue. 

Install the acrylic boards numbered 3 - 4, paying attention to the direction.

Thread all the light strips into the square holes of the bottom plate, paying attention to the direction.

Insert the light strips into the grooves between the acrylic boards and the wooden boards. Note that two layers should be installed to correspond to the two layers of acrylic boards. When the light strips are folded back at the ends, be careful not to break them. The light strips should not protrude from the slots. Finally, cover the bottom plate, make sure to align the bottom, and fix it with glue. 

The assembly is completed. Connect the light strip controller.Lighting up this flame lamp makes one's heart feel warm as well.