comp56

Report

Cooler Acrylic Powder Coated Engraved Sign

Instruction

cooler

.xcs

Show 1 more

Application scenario

Laser processing (45min)

Machine & module

xTool S1

20W

Material used

19 mm pine

powder coating

acrylic

stain

glue (E7000)

722

Information

      Here is a camp sign that has acrylic, pine engraved wood and powder coated image for outdoors.

Preview

This project needed a cool looking labrador dog and what better way to show your cool is to have sunglasses
So AImake to the rescue by asking for just that
It came up with the perfect image
This image was brought into xcs software and was adjusted to fit the oversized pine board
With the sign itself laid out for size it was sent to the machine to engrave the dog
Once the dog was engraved the lettering was cut out from acrylic to be lined up on the board and glued down with very strong E7000 glue
When the dog was deeply engraved a thin layer of powder coating powder was put over the engraved area
With a heat gun the powder was slowly heated until it melted
After the wood cooled it was lightly sanded to clean up the access powder.
Once it was clean and all the letters were dried in place 2 coats of stain sealer was applied all over the sign front and back.
Now the sign is ready for that summer time fun.

Comments