Llaves de madera Papá Noel y Reyes Magos

To design the key of the Three Kings I followed the following steps:

• Insert a rectangle of about 6 x 9 mm. Add a circle at the base so that it is then rounded. 
• We insert a circle of 26 mm and another of 22 mm, center them and click to combine and subtract in superposition. We make two more copies. 
• We place the circles at the top as shown in the images. 
• We insert the drawing of a crown and make two more copies. We center the copies in each of the circles. Select both shapes and click on combine and join. 
• Select all the shapes and click on combine and join. 
• We insert the drawing of another crown, this time with four points, adjust its size and place it at the bottom right to make the shape of the key. Select both shapes and click on combine and join. 
• Finally, we will add the text "Three Kings" (Bambino typeface), create its outline in 2. Place both on the bottom left of the key. Select the outline of the text and the key and click on combine and join. 
• Mark the key to cut and the text to engrave. 

We now have the design of the key of the Three Kings! Now let's go with Santa's key. 

To create Santa's key you have to follow the following steps: 

• Insert a rectangle of about 6 x 9 mm. Add a circle at the base so that it is then rounded. 
• We insert a star and create its outline in 4 because we want the edges to be rounded. We copy it and make it smaller. We align both vertically and horizontally. Select both and click on combine and subtract in superimposition. We place it in the top center. 
• Now we are going to insert a snowflake. We're going to insert a rectangle and we're going to remove the left part, a little less than half. To do this, place the rectangle on the snowflake, select both shapes and subtract it to combine. Now we place what's left of the snowflake at the bottom right of the faucet. Select both shapes and click on combine and join. 
• Insert the text Santa Claus (Bambino typeface), create its outline in 2. We place both in the lower left part of the key. Select the outline and key, click on combine and join. We put the text to engrave. 
• Finally, we will add a drawing of Santa Claus. We create its outline at 0 and place it centered on the star. We select both shapes and click on combine and join. Now we place the drawing of Santa Claus to engrave. 

We have the Santa Claus key ready!

We turn on the Xtool, place the material, check the parameters and hit it to process. 

We let the machine finish its work. 

Once we have the keys, we only have to be clear about where and with what message we want to put them. I show you in the images where I put them.