Slate Coasters

ID 270802
Atomm Exclusive
Instruction
Files
Original files
AuthorF1 · 1/8"(3mm) Basswood Plywood, Rectangular Blank Rock Slate
4
Preview
Add Make Profile
Same design, different machine, material, or any improvement · Earn 50 Credits
Tips for a great Make Profile →
Interlocking parts.

Cut to fit a specific material thickness. If you resize them or change thickness, run Resize slots in Studio first so they still fit together.

gift
7
352

Information

      Create stunning coasters to give out as gifts or just use around your home for the holidays.
    

Instruction

1

Step1

For the coasters, first, sand it down a bit to make it smoother then wash and clean thouroughly. Once done, let it dry completely for 24 hours as the water has absorbed into the slate.

Once dry, apply a single coat of Rust-O-Leum Satin Black paint & primer then let it dry. If it absorbed too much into the slate, apply a second coat.

On the xTool F1 use the inverted png and the following settings:
Laser Type: IR
Dot Duration: 900
Power: 85%
DPI: 600
Bitmap Mode: Jarvis
 

The included 3mm basswood coaster holder can hold 5 typical thickness slate coasters. There are two choices for the front. One with a half moon cutout and the other is solid. There is also a single line under the box in case you are using > 110 mm wide boards.

Comments

Remixes