stephcreated

Report

Snowflake Picture Ornament

Instruction

SnowflakePictureOrnament

.xcs

Application scenario

Laser processing、Inkjet printing

Machine & module

xTool M1 Ultra

20W

Compatibles · 12

Material used

1/8"(3mm) Basswood Plywood

485

Information

      A nice snowflake ornament with spot add to permanent photo.

Preview

Start out by sanding your wood very well.
In order for your print to come out well on wood you will need to prime with the a clear coat.
- For this project. I used modge podge spray.

Preview

Place your wood inside your machine
Make sure you are in the inkjet printing setting in processing mode
Print your image.
Once it's done DO NOT MOVE your material
- replace the inkjet module with the laser module

Change your module mode to lasering on flat surface
Click Go to Process
Once that is done, laser your other pieces as well now that the laser module is in.
- You can change out the wood to some that arent treated with the modge podge if you wish.

Preview

I measured the diameter of my circle that was cut out.
i then went into Silhouette studio and created another diameter that size and placed the pictures inside
Printed the photo on vinyl sticker paper and cut it out with scissors

Preview

After the print came out of the laser I sprayed a coat of modge podge to seal the print.
Place your photo inside the back part of the snowflake
- I used vinyl sticker paper but if you are using a regular photo you can glue or modge podge your photo to the snowflake.
Glue the printed snowflake on top of other snowflake making sure the photo is showing through the frame.