Report

[Laser cut and engrave] Geometric Candle Decoration / Table Lamp — Project made with xTool D1 Pro machine for Laser cut and engrave.

Geometric Candle Decoration / Table Lamp

Instruction

Candle_Decoration

.xs

Application scenario

Laser processing

Machine & module

xTool D1 Pro

10W

Compatible xTool Machine

10W, 20W

F2 Ultra UV

15W

80W

F2 Ultra

40W

F1 Ultra

20W

5W, 10W

5W, 10W, 20W

D1 Pro

5W, 20W, 40W

55W

10W

10W, 20W, 40W

M1 Ultra

10W, 20W

P2S

55W

Material used

1/8"(3mm) Basswood Plywood

320

Information

      I made this for a friend's mother who always checks in on us. It sits around a candle (preferably fake due to being wood) and lays out beautiful geometric shadows.

https://www.pinterest.com/pin/63965257213213966/

TurnMaterialsIntoLight

Instruction

Step1: Adjust settings

Adjust the settings and canvas size to fit your laser and material. Cut.

Step2: Assemble

I used wood glue and clamps to glue the lamp together.

My suggestions:

Lay one of the 6 sides on a slightly raised box, put the glue on either side of the slot and put in the hexagonal frames

Take another side and add the glue in the same way. Place on top, lining up the slots. You can also do the same for the two sides next to this, gravity will keep them in place while drying.

Take the other pieces and add glue next to the slots in the same way. Hold them in place on the frame, then add a clamp to the tabs of the frames that sit through the frame to keep them tight to the frame while it dries.

Comments