Report

[Laser cut and engrave] Axcadia Open 2026 Axe Throwing Tournament Slate Wall Hanging Plaque — Project made with xTool F1 Ultra machine for Laser cut and engrave.

300mm x 200mm Slate Award Plaque, inc Gif and Vector

Instruction

F1 Ultra Axcadia Open 2026 Large Plaques Top

.xs

Application scenario

Laser processing

Machine & module

xTool F1 Ultra

20W

Compatible xTool Machine

3W, 10W, 20W

F2 Ultra UV

5W, 15W

5W, 80W

F2 Ultra

40W, 60W

5W, 10W

2W, 5W, 10W, 20W

D1 Pro

2W, 5W, 10W, 20W, 40W

55W

2W, 10W

2W, 10W, 20W, 40W

M1 Ultra

10W, 20W

P2S

55W

F2 Ultra (Single)

60W

Material used

Rock Stone

100

Information

      This is a Slate Award for axe throwing, including company gif and vector.

This is for a specific venue (Axcadia, great place to throw in Bridgwater, UK), under the IATF ruleset.

Design is quick to run with one pass on slate.
Slate has been sprayed with Acrylic Clear Coat before engraving this allows the engraving to stand out.
Top half is engraved, slate flipped on long side and bottom engraved upside down.
Easy way is to create two separate files.
Hope you enjoy

Instruction

Step1

Ensure slate is clean and dry
Spray with Acrylic Clear Coat before engraving this allows the engraving to stand out (allow to dry for 5 mins before engraving)
Engrave top half
Flip the slate on long side
Refresh camera to ensure placement correct of your design
Engrave bottom half upside down
Easy way is to create two separate files top design, and bottom
I run top and bottom as two different colours. Keep top design as you standard design and run all in one go.
Red is my guide lines that are locked so I can position my changes correctly (unlock them and move to suit your own design)
This design, top half is 3mins 38 secs, bottom half is 1min, 21 secs
Under 5 minutes for an A4 (300mm x 200mm, 12" x 8") design
Hope you enjoy

Comments